Marshall electronic Stereo Amplifier BD 0114 User Manual

BD-0114

VIDEO DISTRIBUTION AMPLIFIER

Marshall

To operate unit, insert the power plug (Marshall V-PS6-1.2A)

into the power jack located on the rear of the unit and twist

the sleeve to lock the connector on. The unit is automatically

turned on when power is supplied to the unit and indicated

by the power LED on the front of the unit. Supply a

NTSC/PAL composite video signal to the video BNC con-

nector labeled VIDEO IN.

Installing the hard mount brackets: Your BD-0114 comes

with two brackets that allow the unit to be hard mounted to

any surface with 4 screws. By removing the middle screw

on the enclosure, position the bracket and then replace the

screw. After both brackets are installed, place the unit in the

desired location and mark the holes using a pencil.

Each unit comes with 4 self-adhesive rubber feet to be

placed on the bottom of the unit to protect any surface that it

may be set upon. Available accessories include a space

saving stand that holds the unit in a vertical position or a rack

mountable face panel that holds multiple units in a 1U space.

For more information please visit www.LCDRacks.com.